How do you string Husqvarna weed eater

Insert end of half 1 trimmer line into hole 1 on spool.Remove the spool, and clean.Remove the old line from the weed eater.How to string your weed whacker.Cut a length of new microfilament line from a roll, using a tape measure to measure the length and a pair of.

If you keep pressing, the string will keep popping up out and being chopped by the cutter on the trimmer head.It is important to know the use of weed eaters properly.Change husqvarna 128cd string with these simple steps.Check if you need.8″ or.6″ line.Press in on the two tabs on either side of the cover hub to release the hub.

Hook the double length of string to the tab on the hub of the spool and pull both strands tight.And then, put it back together, with all of the wire still out.Learn how to start and operate your husqvarna string trimmer with these helpful tips and step by step instructions brought to you by husqvarna and lowe's.whe.Turn off the weed trimmer.Weed eater head, replacement line, and scissors.

Locate the starter hole in the spool.Steps to stringing a weed eater are as follows: